How to get system date in cl program how to#
How to get system date in cl program series#

The copy member source containing the data structure and interface prototype is placed into a source file named QPROTSRC and given the name of DTETIMEDSH.Д**************************************************************************Д* This series of date related values are populated by call to getTodayД tsHHMMSS 6S 0 OVERLAY(tsTimeStampISO:9)Д tsYYYYMMDD 8S 0 OVERLAY(tsTimeStampISO:1)Д tsYYYYMMDDa 8A OVERLAY(tsTimeStampISO:1) The so-called вЂcopy memberвЂ™ also contains the definition of the prototype describing the signature used for the sub-procedure call invoked by the application program. It has been placed into a new source member the primary purpose of which is to copy the Data Structure into all application programs during compile-time using the вЂcopyвЂ™ directive. The data structure that was presented in the post referenced above is augmented as shown here. Providing Current Date and Time using RPG-ILE programming techniques If you need to see an RPG-IV solution, you can see that post here.

The original post represents an older RPG-IV solution where everything is contained within the application program while this post focuses on a modern approach using RPG-ILE service programming.

Some of the the DS values can be used in date-calculations while others are suitable for display on page headers and screens without further formatting.

How to get system date in cl program how to#

Note - The spaces before and after the slash character (/) are mandatory.This post is an extension of the post about how to obtain current date and time into a data structure (DS) which serves to format them in various ways. The current system time in HH:MM:SS format. To configure the 10th of August 2017, run: The current system time is in the HH:MM:SS format. The specified time server does not synchronize to the local clock of Gaia.Д¬onfigures the IP address or Host name of the primary NTP server.Д¬onfigures the IP address or Host name of the secondary NTP server.Д¬onfigures the version number of the NTP - 1, 2, 3 or 4.Д«est Practice - Check Point recommends that you run NTP version 3. Keyword that identifies the NTP server - time server, from which Gaia synchronizes its clock. Shows the IP address or Host name of the NTP server Gaia uses right now. Shows the NTP status (enabled or disabled). Important - After you add, configure, or delete features, run the save config command to save the settings permanently. Select the NTP version for the applicable server.Д®nter the time and date in the applicable fields.Д¬lick Set Time Zone and select the time zone from the list.Д¬onfigure and show the Network Time Protocol (NTP). In the Time and Date Settings window, select Set Time and Date automatically using Network Time Protocol (NTP).Д®nter the Hostname or IP address of the primary and (optionally) secondary NTP servers. In the navigation tree, click System Management > Time. To set time and date automatically using NTP: Best Practice - Configure more than one NTP server for redundancy. It sends periodic time requests to specified servers to synchronize the client computer clock. NTP runs as a background client program on a client computer. Network Time Protocol (NTP) is an Internet standard protocol used to synchronize the clocks of computers in a network to the millisecond.

Manually, using the Gaia Portal, or the Gaia Clish.

You can use these methods to set the system date and time:

To do certificate validation for applications based on the correct time.

To make sure that cron jobs run at the correct time.

SmartEvent correlation uses time stamps that must be synchronized to approximately one a second.

Cluster synchronization requires precise clock synchronization between members.

SIC trust can fail if devices are not synchronized correctly.

TimeДЄll Security Gateways, Security Management Servers and cluster members must synchronize their system clocks. This chapter includes procedures and reference information for system management tasks.